Tektronix 070-A830-51 Amplitude, Offset Accuracy and Rise Time Tests (for option 02)

Performance Verification

Amplitude, Offset Accuracy and Rise Time Tests (for option 02)

These procedures check the accuracy of the AWG710 Arbitrary Waveform

Generator option 02 outputs; amplitude and offset.

Check Amplitude
and
DC Offset
	Equipment	A 504W BNC4coaxial cable, a 504W4precision terminator, an
	required	SMA￿Ma￿5BNC￿Fe￿4adapter, BNC ￿female￿5to5dual banana adapter, and
		a digital multimeter ￿DMM￿.
	Prerequisites	The AWG710 option 02 Arbitrary Waveform Generator must meet the
		prerequisites listed on page￿4-8.

Do the following steps to install the test hookup and set the test equipment controls:

1.Use a 50 W BNC coaxial cable, an SMA(Ma)-BNC(Fe) adapter, a 50 W precision terminator, and a BNC-to-dual banana adapter to connect the AWG710 Arbitrary Waveform Generator CH1 output to the DMM input connector (see Figure 4±12).

AWG710 option 02 Arbitrary Waveform Generator

50 W BNC4coaxial cable

CH14output4connector

+4SMA￿Male￿5BNC￿Female￿ adapter +4BNC 50 W4precision terminator +450 W4BNC coaxial cable

Input4connector +4BNC5to5dual banana adapter +450 W BNC4coaxial4cable

DMM

Figure 4-12: Option 02 output amplitude accuracy initial test hookup

2.Set the DMM controls as follows:

Mode . . . . . . . . . . . . . . . . . . . . . . . . . .	VDC
Range . . . . . . . . . . . . . . . . . . . . . . . . .	2 V
Input . . . . . . . . . . . . . . . . . . . . . . . . . .	Front

AWG710 Service Manual 4-31