Adjustment Procedures
Enabling Service Mode All the adjustment procedures are obtained through the Service menu which is a submenu of the Utility menu. To enter this menu, you must enable the Service mode using the switch on the A10 Connector board. Perform the following step:
Power on the waveform generator by pushing ON/STBY button while pressing the service switch on the A10 Connector board. See Figure 5±1.
If you perform the adjustment procedure without removing the cabinet, you must insert the adjustment tool (Table 5±4, Item 7) in the hole on the left side of the waveform generator to engage the service switch.
Toggle the ON/STBY button to STBY to disable the Service mode.
10 onnector board
Service switch
djustment tool
Figure
AWG710 Service Manual |