Removal and Installation Procedures

Procedures for External Modules

Do the Accsess Procedure on page 6±16 before performing any of the procedures in this subsection.

The following procedures are listed in the order presented.

￿Front Panel Knobs

￿Line Fuse and Line Cord

￿EMI Gaskets

￿Cabinet

￿Trim Ring

￿A20 Front Panel Assembly

￿Output Assembly

￿Cabinet Modules

Front Panel Knobs You will need angled-tip tweezers (Table 6±4, Item 10).

1.Find the knob(s) to be removed on the front panel.

2.Orient the waveform generator so the bottom is on the work surface and the front is facing you.

3.Remove the knob(s) by pulling it straight out from the front panel to create some clearance between the base of the knob and the front panel. Insert the tweezers between the knob and the front panel and remove the knob. See Figure 6±6.

4.To install, align the knob to the shaft and push in until it snaps into place.

AWG710 Service Manual

6-17