Removal and Installation Procedures
Trim Ring No tools are needed for this procedure.
1.Locate the modules to be removed in Figure 6±2, page 6±12.
2.Orient the generator so the rear is on the work surface and the bottom is facing you.
3.Remove the front cover by grasping it by the left and right edges and snap it off of the front subpanel. When installing, align and snap back on. See Figure 6±9.
Trim Ring. When removing the trim ring, grasp its back edge and vigorously flex it upward before pulling it forward.
Menu buttons
Output panel
Figure
AWG710 Service Manual |