Performance Verification
Loading Files The following steps explain how to load files from the Performance Check/Ad- justment disk into the waveform memory and/or sequence memory.
1.Insert the disk into the AWG710 Arbitrary Waveform Generator floppy disk drive.
2.Select SETUP (front)Waveform/Sequence (bottom)Load... (side) Drive... (side).
The Select Drive dialog box appears as shown in Figure 4±4.
Figure
3.Select Floppy from the dialog box using the general purpose knob, and then push the OK side button.
The Select Drive dialog box disappears and the files in the floppy disk are listed on the Select File dialog box.
4.Use the general purpose knob to select a file to load from the dialog box, and then push the OK side button.
The waveform or sequence you selected is loaded into the instrument, and the instrument is also setup with the parameters stored in that file.
5.Remove the floppy disk from the floppy disk drive if the floppy disk is no longer needed.
6.Push any bottom button or menu button to exit the menu.
AWG710 Service Manual |