Removal and Installation Procedures

CPU board

￿40 PCI Interface board

￿PIB board

Figure 6-20: CPU, A40 PCI Interface, and GPIB boards removal

5.Remove the A40 PCI Interface board (using a screwdriver with a size #2 Phillips tip) by removing the screw on the left side of the board. See Figure 6±20.

6.Grasp the board and slide it out.

7.Remove the GPIB board (using a screwdriver with a size #2 Phillips tip) by removing the screw on the left side of the GPIB board. See Figure 6±20.

8.Grasp the board and slide it out.

9.Remove the Back Plane (using a screwdriver with a size #2 Phillips tip) by removing the four screws securing the board to the frame. See Figure 6±20.

10.Grasp the board and slide it out.

11.To install, do this procedure in reverse order.

12.Refer to the Cabinet procedure on page 6±20 to complete the assembly of the waveform generator.

6-40

AWG710 Service Manual