Removal and Installation Procedures
P3
To J154
on the Connector board
FrontPanel assembly
Back of
P2
Figure
If the front panel or the front panel buttons need service, do the following steps:
7.Remove the front panel control knobs from the front panel assembly using the method described in Front Panel Knobs on page 6±17.
8.Remove the eight screws that mount the front panel board to the front panel.
9.Hand disassemble the front panel assembly components using Figure 6±11 as a guide. Do this procedure in reverse order to reassemble using Fig- ure 6±11 as a guide.
10.To install, reverse this procedure.
AWG710 Service Manual |