Maintenance
This section contains the information needed to perform periodic and corrective maintenance on the AWG710 Arbitrary Waveform Generator.
The following subsections are included:
Related Maintenance Procedures. Provides information relating to various sections discussing maintenance.
Preparation. Introduction plus general information on preventing damage to internal modules when doing maintenance.
Inspection and Cleaning. Information and procedures for inspecting the waveform generator and cleaning the external and internal modules.
Removal and Installation Procedures. Procedures for the removal of defective modules and replacement of new or repaired modules.
Troubleshooting. Information for isolating failed modules. Included are instructions for operating the waveform generator internal diagnostic routines and troubleshooting trees. Most of the trees make use of these internal diagnostic routines to speed fault isolation to a module.
Related Maintenance Procedures
The following subsections contain information and procedures related to maintenance.
Operating Information provides useful troubleshooting instructions when operating the waveform generator. It also details the service strategy and lists options for obtaining maintenance service and replacing failed modules.
Theory of Operation contains a circuit description at the module, or block, level.
Performance Verification provides procedures that may be useful in isolating modules problems by testing the waveform generator performance.
Adjustment Procedures addresses after repair adjustment and the interval between periodic adjustments. It contains a procedure for adjusting the internal circuits of the waveform generator.
Diagrams contains a block diagram using individual modules as blocks and an interconnection diagram showing connections between the modules.
Replaceable Mechanical Parts lists all field replaceable modules by part number.
AWG710 Service Manual |