Removal and Installation Procedures

Line Fuse and Line Cord You will need a flat-blade screwdriver (Table 6±4, Item 4). Locate the line fuse and line cord in Figure 6±2.

W￿RNING￿ To avoid electrical shock, be sure that the power cord is disconnected from the socket before checking the line fuse.

1.Orient the generator so the bottom is on the work surface and the rear is facing you.

2.Disconnect the line cord from the rear panel connector and main power.

3.If you are servicing the line fuse, do the next step; if you are servicing the line cord, skip to step 5.

4.Find the fuse cap on the rear panel. See Figure 6±7. Remove the fuse cap by turning it counterclockwise using a flat-blade screwdriver and remove the line fuse.

5.Find the line cord on the rear cover. See Figure 6±7. Pull the line cord to complete the removal. Do the procedure in reverse order to install.

6.Do steps 4 and 5 in reverse order to install the line cord and line fuse.

Line Fuse

Fuse Cap

Figure 6-7: Line fuse and line cord removal

AWG710 Service Manual

6-19