Adjustment Procedures
3.Do the following to set the waveform generator controls: Press UTILITY System Factory Reset OK.
4.Follow the substeps below to load the waveform:
a.Press SETUP Waveform/Sequence Load...
b.Turn the general purpose knob to display the list of waveform files and highlight the file MODE.WFM.
Press OK to select and load the file.
c.Press the RUN button.
d.Press the CH1 OUTPUT button to ON.
5.Adjust Magic Frequency:
a.Press UTILITY Service
b.Turn the general purpose knob to select Tweak AWG2.
c.Press OK.
d.Press Magic Freq. .
e.Turn the general purpose knob to adjust the waveform on the oscillo- scope display so that the corruption of the waveform becomes the maximum.
6.Press Save to save the setting.
7.Disconnect the oscilloscope.
AWG710 Service Manual |