Removal and Installation Procedures

This subsection contains procedures for removal and installation of all mechanical and electrical modules. Any electrical or mechanical module, assembly, or part listed in the Replaceable Mechanical Parts section of this manual is a module.

Preparation ￿ Preparation for Use

W￿RNING￿ Before doing this or any other procedure in this manual, read the Safety Summary found at the beginning of this manual. Also, to prevent possible injury to service personnel or damage to the generator components, read Operating Information:Installation and Preventing ESD in this section.

This subsection contains the following items:

￿Preparatory information that you need to properly do the procedures that follow.

￿List of tools required to remove and disassemble all modules.

￿Three module locator diagrams for finding the External Modules (see Figure 6±2), Outer-Chassis Modules (see Figure 6±3), and Inner-Chassis Modules (see Figure 6±5).

￿Procedures for removal and installation of the electrical and mechanical modules.

￿A disassembly procedure for removal of all major modules from the generator at one time and for reassembly of those modules. A complete disassembly is normally only done when completely cleaning the generator. (Instructions for doing the actual cleaning are found under Inspection and Cleaning at the beginning of this section.)

￿Module disassembly procedures.

W￿RNING￿ Before doing any procedure in this subsection, disconnect the power cord from the line voltage source. Failure to do so can cause serious injury or death.

AWG710 Service Manual

6-9