Removal and Installation Procedures
Display Assembly You will need a screwdriver with a size #2 Phillips tip (Table 6±4, Items 1 and 3).
1.Locate the modules to be removed in Figure 6±3, on page 6±13.
2.Do the Trim Ring, Menu Button and A20 Front Panel Assembly procedures immediately preceding this procedure.
3.Orient the waveform generator so the bottom is on the work surface and the front panel is facing you (see Figure 6±16).
4.Unplug the LCD and Back Light connectors J225 and J245 on the A10 Connector board.
5.Unplug the LCD connector on the right side of the LCD display by pushing toward the rear panel.
6.Remove the four screws on the top and bottom of the display frame that mount the display assembly to the chassis.
7.Remove the display frame, filter, and filter retainer.
8.Remove the LCD display and bracket by pulling it out from left side.
Display assembly
Figure
9.To install, do this procedure in the reverse order.
AWG710 Service Manual |