Removal and Installation Procedures
CPU unit This procedure describes how to remove the following circuit boards that are contained in the CPU unit:
CPU board
Hard Disk and Flash Disk
A40 PCI Interface Board
GPIB Board
Back Plane
NOTE. The Lithium polycarbon monofluoride battery on the CPU board is not
You will need a screwdriver with a size #2 Phillips tip (Table 6±4, Items 1 and 3).
1.Locate the modules to be removed in Figure 6±4, page 6±14.
2.Orient the waveform generator so the bottom is on the work surface and the right side is facing you.
3.Remove the CPU unit using Figure 6±19 as a guide while doing the following substeps:
a.Unplug the GPIB interconnect cable at the GPIB board and the LAN interconnect cable and the VGA and COM1 interconnect cable at the CPU board.
b.Unplug the LCD flat cable, FDD flat cable, HDD IDE flat cable, and the MISC flat cable at the CPU board.
c.Unplug the two flat cables from the A50 Sequence board and the flat cable from the A10 Connector board at the A40 PCI Interface board.
d.Remove the two screws on the bottom and the two screws on the right side.
e.Lift the CPU Unit up and out from the main chassis.
AWG710 Service Manual |