Removal and Installation Procedures

Accsess Procedure

Begin with this procedure when you have identified which module to remove for service.

1.Find the module to remove in Figure 6±2 through 6±5.

The title of the figure indicates whether the module is an external, internal module(1), or internal module(2) part.

2.If the module is externally mounted and no internal access is required, remove the module. Follow the steps in Procedures for External Modules on page 6±17.

3.If the module is an internal-chassis module and access is required inside of the instrument; do the Line Fuse and Line Cord procedure followed by the Cabinet procedure. Both procedures are in the Procedures for External Modules subsection.

4.After completing those procedures, return to this procedure and continue with step 5.

5.If the module is an internal module(1), access the inner-chassis.

a.If removing the output assembly or display unit, first do the Trim Ring found in Procedures for External Modules (page 6±17).

b.Find and do the procedure for the module to be removed in Procedures for Internal Modules (1) on page 6±30.

6.If the module is an internal module(2), access the reverse side of the chassis. Since the module is assembled by three classes, perform the following steps in the order listed.

a.Find and do the procedure for the module you want to remove in Procedures for Internal Modules (2), page 6±44.

b.Do the procedure A10 Connector Board found in Procedures for Internal Modules (1), page 6±30.

7.Install all modules previously removed. Read the module removal for service instructions found at the end of the procedure. These instructions will guide you in installing all modules previously removed.

6-16

AWG710 Service Manual