Introduction
This manual provides information and procedures necessary for properly servicing the AWG710 Arbitrary Waveform Generator, as well as general information critical to safe and effective servicing.
To prevent personal injury or damage to the waveform generator, review the following information before attempting service:
The procedures in this manual should be performed only by qualified service personnel.
Read the General Safety Summary and Service Safety Summary beginning on page xi.
Read Preparation for Use in the Operating Information subsection.
When using this manual for servicing, be sure to follow all warnings, cautions, and notes.
Performance Verification Procedures
Complete the performance check described in the Performance Verification section every 12 months. In addition, a performance check is recommended after module replacement.
If the waveform generator does not meet performance criteria, repair is necessary.
Strategy for Servicing
Throughout this manual the term, module, refers to any
This manual contains all the information needed for periodic maintenance of the waveform generator. Further, it contains all information for corrective maintenance down to the module level. To isolate a module failure, follow the troubleshooting procedures found in the Maintenance section. To remove and replace any failed module, follow the instructions in the Removal and Installation Procedures subsection. After isolating a faulty module, replace it with a fully tested module obtained from the factory. The Replaceable Mechanical Parts subsection contains part number and ordering information for all replaceable modules.
AWG710 Service Manual | xix |