Removal and Installation Procedures
List of Modules The Replaceable Mechanical Parts section lists all modules.
Summary of Procedures The following procedures are described in the order in which they appear in this section.
The Accsess Procedure on page 6±16 directs you to the procedure(s) (if any) that are required to access the module to be serviced, then it directs you to the procedure to remove that module.
Procedures for External Modules on page 6±17 explain how to remove modules that do not require internal access to the waveform generator.
Procedures for Internal Modules (1) on page 6±30 are procedures for removing modules which require access to the internal part of the waveform generator but are external to the chassis.
Procedures for Internal Modules (2) on page 6±44 are procedures for removing modules which require access to the internal part of the waveform generator and are internal to the chassis.
Equipment Required. Most modules in this generator can be removed using a screwdriver with a size #2, Phillips tip. Use this tool whenever a procedure step instructs you to remove or install a screw unless a different size screwdriver is specified in that step. All equipment required to remove and install a module are listed in the first step of each procedure.
Table
Item no. | Name | Description |
|
|
|
1 | Screwdriver handle | Accepts Phillips2driver bits |
|
|
|
2 | #1 Phillips tip | Phillips2driver bit for #1 screw size |
|
|
|
3 | #2 Phillips tip | Phillips2driver bit for #2 screw size |
|
|
|
4 | Flat2blade screwdriver | Screwdriver for removing |
|
| screws |
|
|
|
5 | Needle2Nose Pliers | Standard tool |
|
|
|
6 | Nutdriver, 1@inch | Standard tool |
| 2 |
|
7 | Nutdriver, 5.5 mm (7/32 inch) | Standard tool |
|
|
|
8 | Nutdriver, 7 mm (9/32 inch) | Standard tool |
|
|
|
9 | Retaining Ring Pliers | Standard tool |
|
|
|
10 | Angle2Tip Tweezers | Standard tool |
|
|
|
11 | Soldering Iron | Standard tool |
|
|
|
12 | Pliers | Standard tool |
|
|
|
13 | Solder Wick | Standard tool |
|
|
|
AWG710 Service Manual |