Operating Basics
Composition and Setup of Output Channel
Use the Setup menu to set up parameters for each channel as well as the instrument.
Set up the file to load, amplitude, and run mode for each channel. Set up the Horizontal, Run Mode, and Trigger for the instrument.
Loading a Waveform File Do the following steps to load a waveform file into the Setup screen: to Output
1.Push the Waveform/Sequence bottom menu button. This opens the Waveform/Sequence side menu.
2.Push the Load... side button. The instrument opens the Select File list as shown in Figure 2±24.
Figure
3.Use the general purpose knob or arrow buttons to select the file name to load. If the file you want to load is located in a different drive or directory, use the side menu buttons to change the current drive/directory.
4.Push the ENTER front panel button or OK side button. The instrument loads the file and displays the file name in the selected channel file icon. Push the Cancel side button to exit the file load process.
The procedures above explain how to load a waveform or pattern into the waveform memory, and/or sequence file into the sequence memory, which will be scanned to output. The waveform memory, sequence memory, and the edit
AWG710 Service Manual |