Specifications
Certification and Compliances
The certification and compliances for the AWG710 Arbitrary Waveform | ||
Generator are listed in Table 1±22. See Table 1±23 for installation categories and | ||
pollution degree descriptions. | ||
Table |
| |
|
|
|
Characteristics | Description |
|
|
| |
EC declaration of conformity | EC council EMC Directive 89/336/EEC, amended by 89/336/EEC; | |
| Product Family Standard for Electrical Equipment for Measurement, Control, and | |
| Laboratory | |
| Emissions: |
|
| EN 61326 | EMC requirements for class A electrical equipment for |
|
| measurement control and laboratory use. |
| EN 61000?3?2 | AC power line harmonic emissions |
| Immunity: |
|
| IEC 61000?4?2 | Electrostatic Discharge Immunity |
| IEC 61000?4?3 | Radiated RF Electromagnetic Field Immunity |
| IEC 61000?4?4 6 | Electrical Fast Transient/Burst Immunity |
| IEC 61000?4?5 | Surge Immunity |
| IEC 61000?4?6 | Conducted Disturbances Induced by RF Field Immunity |
| IEC 61000?4?11 | Power Line Interruption Immunity |
| Compliance was demonstrated to the following specification as listed in the Official Journal | |
| of the European Communities: | |
| Low Voltage Directive 73/23/EEC, amended by 93/68/EEC | |
| EN 61010?1/A2:1995 | Safety requirements for electrical equipment for measure? |
|
| ment, control, and laboratory use |
|
| |
Australia/New Zealand declaration of | Conforms with the following standards in accordance with the Electromagnetic Compatibili? | |
conformity - EMC | ty Framework: |
|
| AS/NZS 2064.1/2 | Class A radiated and Conducted Emissions |
|
| |
Safety | UL3111?1 - Standard for electrical measuring and test equipment | |
Third+party+certification | CAN/CSA C22.2 No. 1010.1 - Safety requirements for electrical equipment for measure? | |
| ||
| ment, control and laboratory use | |
Self+declaration | IEC 61010?1/A2:1995 - Safety requirements for electrical equipment for measurement, | |
| ||
| control, and laboratory use |
|
|
| |
Installation category | Power input ? Installation Category II as defined in IEC 61010?1, Annex J | |
|
| |
Pollution degree | Pollution Degree 2 as defined in IEC 61010?1 | |
|
|
|
6Up to 200 mV p,p noise is allowed on the output during this test.
AWG710 Service Manual |