Operating Basics

QUICK EDIT button

Enters the QUICK EDIT mode from the waveform editor. This button allows you to edit waveforms that have immediate effect on the output signal. Use together with the VERTICAL and HORIZONTAL controls for quick edit.

RUN button

Enables waveform output. The signal output depends on the RUN mode settings.

VERTICAL controls

Used to control the output vertical axis parameters.

Pushing the VERTICAL MENU button displays the VERTICAL side menu. This is the same as selecting SETUP ￿front￿￿ Vertical ￿bottom￿.

The OFFSET knob adjusts the vertical offset.

The LEVEL/SCALE knob adjusts the amplitude.

TRIGGER controls

Controls the trigger parameters.

Pushing the TRIGGER MENU button displays the Trigger side menu. This has the same effect as pushing SETUP ￿front￿￿Trigger ￿bottom￿.

The LEVEL knob adjusts the trigger level.

FORCE TRIGGER button

Pushing the FORCE TRIGGER button generates an internal trigger event.

FORCE EVENT button

Pushing the FORCE EVENT button generates an internal event signal.

HORIZONTAL controls

Used to control the output horizontal axis parameters.

Pushing the HORIZONTAL MENU button displays the Horizontal side menu. This is the same as selecting SETUP ￿front￿￿Horizontal ￿bottom￿.

When in Quick Edit mode, the OFFSET knob adjusts the horizontal position.

The SAMPLE RATE/SCALE knob adjusts the clock frequency.

Figure 2-5: Front panel keypad area

Rear Panel Figure 2±6 shows the rear panel signal and power connectors.

￿￿UTION￿ To prevent damage to the instrument, apply signals only within the stipulated range to the INPUT connector.

Do not apply any external voltage to the OUTPUT connector.

2-16

AWG710 Service Manual