Removal and Installation Procedures
Hard disk and Flash disk This procedure describes how to remove the Hard Disk and Flash Disk unit.
You will need a screwdriver with a size Phillips #2 tip (Table 6±4, Items 1 and 3).
1.Locate the modules to be removed in Figure 6±4, page 6±14.
2.Orient the waveform generator so the bottom is on the work surface and the front is facing you.
3.The hard disk unit is beneath the A10 board. Do the A10 Connector board removal procedure (page 6±24) before continuing this procedure.
4.Unplug the IDE interface cable from the IDE interface connector on the disk drive.
5.Use a screwdriver with a size Phillips #2 tip to remove the four screws that secure the hard disk and flash disk bracket to the chassis. See Figure 6±21.
6.Remove the four screws that secure the hard disk drive and the flash disk drive to the bracket.
Flash disk
Hard disk
Figure
AWG710 Service Manual |