Removal and Installation Procedures
Fan You will need a screwdriver with a size #2 Phillips tip (Table 6±4, Items 1 and 3).
1.Locate the fan in Figure 6±3 on page 6±13.
2.Orient the waveform generator so the bottom is on the work surface and the left side is facing you (see Figure 6±14).
3.Slide the cable connector at the fan to unplug the cable from the Connector board at J310.
4.Remove the four screws that secure it to the main chassis and lift the fan out. The large fan uses spacer posts.
5.To install, do the steps in reverse order. Refer to the Cabinet procedure, on page 6±20, to complete the generator assembly.
J310
A10 Connector Board
Figure
AWG710 Service Manual |