Removal and Installation Procedures
7.While using the pliers to expand the handle cap outward, grasp it and snap it off.
8.Repeat the procedure to remove the remaining cap as needed; push the cap(s) back on to install.
9.Remove the flip stand by grasping it on both sides where it joins each flip stand foot. Now compress the flip stand until the flip stand ends clear the flip stand feet to complete the removal.
10.To remove the flip stand foot or feet, do the Cabinet procedure (page 6±20) to gain access to the inside of the cabinet.
11.Working from inside the cabinet, push the two retainers to release the flip stand foot you wish to remove and lift it away from the outside of the cabinet.
12.Repeat this procedure to remove as many of the remaining feet as needed. Insert the two retainers back into their slots in the cabinet and snap any flip stand foot, previously removed, into place.
13.To install, reverse this procedure.
AWG710 Service Manual |