E6580757
4.1.1How to set the basic parameters
Basic parameters
All of the basic parameters can be set by the same step procedures.
[Steps in key entry for basic parameters]
Switches to the setting monitor mode.
Selects parameter to be changed.
Reads the programmed parameter setting.
Changes the parameter setting.
Saves the changed value of the parameter setting.
* | The inverters are |
|
| shipped from the |
|
| factory with set |
|
| parameters by default. |
|
* | Select the parameter to |
|
| be changed from "Table |
|
| of parameters". |
|
* | If there is something |
|
| that you do not |
|
| understand during the |
|
| 4 | |
| operation, press the | |
| MON key to return to |
|
|
|
the 
indication.
Steps in setting are as follows (the example shown is one of changing the maximum frequency from 80Hz to 60Hz).
Key operated | LED display |
|
|
| Operation |
| |
|
|
|
| ||||
|
| Displays the operation frequency (operation stopped). (When stan- | |||||
|
| dard monitor display selection | is set to 0 [operation fre- | ||||
|
| quency]). |
|
|
|
|
|
|
| Press the MON key to display the first basic parameter | |||||
|
| (automatic acceleration/deceleration). |
| ||||
|
| Press either the |
| key or the | key to select " | ". | |
|
|
| |||||
|
|
|
|
|
|
|
|
|
| Pressing the ENTER key reads the maximum frequency. | |||||
|
|
|
|
| |||
|
| Press the | key to change the maximum frequency to 60Hz. | ||||
|
|
|
| ||||
|
| Press the ENTER key to save the changed maximum frequency. | |||||
|
| and frequency are displayed alternately. |
| ||||
After this, | → Displays the same | → | Switches to the | → | Displays names | ||
| programmed pa- |
| display in the |
| of other parame- | ||
| rameter. |
| status monitor |
| ters. | ||
|
|
|
| mode. |
|
| |
