E6580757
Set parameters as follows to adjust the output frequency up or down almost in synchronization with the adjustment by the panel frequency command:
= = 1
[ (or ) / ] ≤ ( setting time)
[ (or ) / ] ≤ ( setting time)
<<Sample sequence diagram 1: Adjustment with continuous signals>>
RUN command
Incrementing (UP) signal
Decrementing (DOWN) signal
Set frequency clearing signal
Upper limit frequency
Gradient:
Lower limit frequency
Gradient:
Frequency |
| 6 |
|
| |
0Hz | The dotted line denotes the output frequency obtained by combining the slowdown speed and the panel |
|
| ||
| frequency adjustment speed. |
■Adjustment with pulse signals (Parameter-setting example 2)
Set parameters as follows to adjust the frequency in steps of one pulse:
, > Pulse ON time > 32msec
, = Frequency obtained with each pulse
*If signal input time less than setting , is not responded. 12ms or more of clearing signal is allowed.