Xantrex Technology XDC manual Device-Specific Error List, Error Error Message Description Code

Error Messages

Device-Specific Error List

Device-Specific Error List

An error in the range [-399, 300] or [1, 32767] indicates that the instrument has detected an error which is not a command error, a query error, or an execution error; some device operations did not properly complete, possibly due to an abnormal hardware or firmware condition. These codes are also used for self-test response errors. The occurrence of any error in the class causes the device-specific error bit (bit 3) in the Event Status Register to be set.

Table C.3 Device-Specific Error List

Error	Error Message Description
code
-300	Device-specific error.
	Indicates that the power supply could not complete the operation due to some
	condition of the power supply.
-310	System error.
	This error is queued when the power supply cannot convert the input to a
	calibrated value.
-313	Calibration memory lost.
-314	Save/recall memory lost.
	Indicates that the non-volatile data saved by the *SAV command has been lost.
-315	Configuration memory lost.
	Indicates that non-volatile configuration data saved by the power supply has
	been lost.
-321	Out of memory.
	An internal operation needed more memory than was available.
-330	Self-test failed.
-350	Queue overflow.
	A specific code entered into the queue in lieu of the code that caused the error.
	This code indicates that there is no room in the queue and an error occurred
	but was not recorded.
-360	Communication error.
	This is the generic communication error for errors which cannot be classified
	below.
-361	Parity error in program message.
	Parity bit not correct when data received.
-362	Framing error in program message.
	A stop bit was not detected when data was received, e.g. a baud rate
	mismatch.
-363	Input buffer overrun.
	Software or hardware input buffer on serial port overflows with data caused by
	improper (or nonexistent) pacing.

218 Operating Manual for XDC Series Power Supply