Network Settings
4-32 41-001160-00, Release 2.1, Rev 04
IP Phone Administrator Guide
Configuring the IP Phones
The following parameters allow an administrator to configure ToS, QoS, and
DiffServ QoS for VLAN:
Parameters in Configuration Files Parameters in Aastra Web UI
Global
tagging enabled VLAN enable
priority non-ip Priority, Non-IP Packet
LAN Port
vlan id VLAN ID
tos priority map SIP Priority
tos priority map RTP Priority
tos priority map RTCP Priority
PC Port
vlan id port 1 VLAN ID
QoS eth port 1 priority Priority
Notes:
1. In order for the software to successfully maintain connectivity with a
network using VLAN functionality, the IP phone reboots if you modify
the "tagging enabled" (VLAN Enable in the Web UI), "vlan id", or
"vlan id port 1" parameters.
2. When the LAN Port (vlan id) and the PC Port (vlan id port 1)
parameters have the same value, VLAN functionality is compatible with
earlier IP phone software releases.
If you set the PC Port (vlan id port 1) to 4095, all untagged packets are
sent to this port. For configuring this feature via the Phone UI and the
Aastra Web UI, see “Configuring VLAN (optional)” on page4-37. For
configuring this feature using the configuration files, see Appendix A, the
section, “Virtual Local Area Network (VLAN) Settings” on pageA-26.