Aastra Telecom 53I, 57I CT, 55I manual Configuring a Park/Pickup Key Using Aastra Web UI

Configuring Operational Features

Operational Features

Configuring a Park/Pickup Key Using Aastra Web UI

On the 57i/57i CT, you configure a Park and/or Pickup key at Operation->Softkeys and XML. You enter a key label, and value for a specific line on the phone. The default state of the Park configuration is "connected". The default state of the Pickup configuration is "idle, outgoing".

The 57i CT handsets use the park/pickup configuration enabled at Operation->Handset Keys in the Aastra Web UI. If Park or Pickup are enabled on more than one line on the base unit, the 57i handset uses the first programmable configuration.

For example, if line 1 and line 6 are configured for park, the 57i CT handset uses the configuration set for line 1 to park a call.

On the 53i, you configure a Park and/or Pickup key at Operation->Programmable Keys, and then enter the appropriate value and line.

Note: Applicable values depend on the server in your network (Asterisk, BroadWorks, Sylantro, ININ PBX. See the table below for applicable values.

Park/Pickup Call Server Configuration Values

Server	Park Values*	Pickup Values*
Aasterisk	70	70
Sylantro	*98	*99
BroadWorks	*68	*88
ININ PBX	callpark	pickup

*Leave "value" fields blank to disable the park and pickup feature.

Use the following procedure to configure the Park/Pickup call feature using the programmable configuration method and the Aastra Web UI.

Operational IP Phone Features

41-001160-00, Release 2.1, Rev 04 5-157