Document No. 10-300090, Issue 1 16-7
Logging
power Logs the a ddition or removal of a power supply
service_port Logs status changes in service ports.
Use the set port category command to set a port as
a service port. For information on this command,
see Chapter21. This feature makes it possible for
you to use different notification levels for critical
(service ports), if desired.
user_port Logs status changes in user ports.
Use the set port category command to set a port as
a user port. For information on this command, see
Chapter 21. This feature makes it possible for you
to use different notification levels for critical
(service ports), if desired.
auth_failure Logs authentication failures. This is a security-
related feature used to detect unauthorized SNMP
activity.
bridge_stat Logs changes in bridge status.
switch_fabric Logs failures in the switch fabric. These failures
are critical and should be monitored closely.
ospf Logs OSPF events if OSPF protocol event logging
is enabled.
dvmrp Logs DVMRP events, if DVMRP event logging is
enabled.
rip Logs RIP events if RIP protocol event logging is
enabled.
ldap Logs LDAP events if LDAP protocol event
logging is enabled.
cli Logs CLI events, if CLI event logging is enabled.
snmp Logs SNMP events, if SNMP protocol event
logging is enabled.
appletalk Logs AppleTalk events if AppleTalk protocol event
logging is enabled.
redundant_cpu Logs changes in status of a redundant CPU.
Notification is sent if:
• The status changes from standby to active or
vice versa.
• The active superviso r loses or establishes
contact with the standby supervisor.
Table 16-2. Parameters, Keywords, ArgumentsName Definition
2 of 3