Avaya 106760804 manual Appletalk cable-range, Sample Output

	Appletalk
appletalk cable-range
Command Mode	Interface Configuration.
Description	Configure a cable range for an Appletalk Phase II for an interface. The no
	form of this command disables Appletalk for this interface.

Syntax

To Enable:	appletalk cable-range<cable-range> [<network.node>]
To Disable:	[no] appletalk cable-range

	Table 3-5. Parameters, Keywords, Arguments
	Name	Definition
	<cable-range>	An optional parameter to indicate the range of the Appletalk
		network values to be used on this interface. Specify start
		and end values between 0 and 65279 and separate the values
		with a hyphen.
		The starting network number must be less than the ending
		network number. When <cable-range>is omitted, the
		interface tries to configure the Appletalk network and
		obtains its configuration from another Appletalk router.
	<network.node>	The Appletalk network address to assign to the interface.
		When <network.node> is omitted, the Appletalk address
		defaults to 0.0.
		• network - A 16-bit network number between 0 and
		66279.
		• node - An 8-bit node number between 0 and 254.
Sample Output	The following example configures a cable range of 222-224 for the
	Appletalk interface on serial port 0.
	(config-if:serial0)#appletalk cable-range 222.244
Systems	P550R, P580, P880, and P882.

Document No. 10-300090, Issue 1 3-7