Avaya 106760804 manual Access-list

Chapter 20

access-list

Command Mode	Global Configuration.
Description	Creates a rule in an access control list (ACL). The rule that you set is
	applied on all of the ports on the switch.
	* Note: You must enable the ACL on which you want to set a rule. Only
	one ACL can be enabled at a time.
	The no command deletes an ACL rule or ACL.
Syntax
	To Create a	access-list<access-list-name> <access-list-index>
	Standard	{permit [{use-priority <priority> use-diffserv [mask]
	ACL Rule:	remark-diffserv <dscp> [mask] use-l2}] deny fwd1
		fwd2 fwd3 fwd4 fwd5 fwd6 fwd7 fwd8}
		{<source-ip-addr> <source-wildcard> any host
		<source-ip-addr>}
	To Create an	access-list<access-list-name> <access-list-index>
	Extended	{permit [{use-priority <priority> use-diffserv [mask]
	ACL Rule:	remark-diffserv <dscp> [mask] use-l2}] deny fwd1
		fwd2 fwd3 fwd4 fwd5 fwd6 fwd7 fwd8}
		<protocol-id> {<source-ip-addr> <source-wildcard>
		any host <source-ip-addr>} [{lt <port> eq <port>
		gt <port> range <port> <port>}] {<dest-ip-addr>
		<dest-wildcard> any host <dest-ip-addr>} [{lt
		<port> eq <port> gt <port> range <port> <port>}]
		[established]
	To Remove an	no access-list<access-list-name> [<access-list-index>]
	ACL Rule or
	ACL:

20-2 Command Reference Guide for the Avaya P580 and P882 Multiservice Switches, v6.1