Avaya 106760804 Set port flow-control, Configure# set port flow-control 3 enable-receive-only

Port

set port flow-control

Command Mode	Global Configuration.
Description	Set the port flow control.
	* Note: Setting this parameter on any M5548-100TX port sets all
	physical ports on the module to the same value.
Syntax	set port flow-control{<mod-num> <mod-port-range>}[...,{<mod-num>
	<mod-port-range>}] {disable enable enable-receive-only enable-send-
	only enable-with-aggressive-backoff}
	Table 21-15. Parameters, Keywords, Arguments
	Name	Definition
	<mod-num>	Specifies the number of the module where the flow control
		for each port on the module is to be set.
	<mod-port-range>	Specifies the range of ports whose flow control is to be set.
	{disable enable	The flow control options are:
	enable-receive-only	•	disable - Disables flow control for specified ports.
	enable-send-only
			Turns off an attached device's ability to send flow-
	enable-with-
			control packets to a local port.
	aggressive-backoff}
		• enable - Enables flow control for specified ports.
			Turns on an attached device's ability to send flow-
			control packets to a local port.
		•	enable-receive-only- Enables receive only for the
			specified gigabit ports. Indicates that a port only
			receives administrative status from a remote device.
		•	enable-send-only- Enables send only for the
			specified gigabit ports. Indicates that a port only
			sends administrative status from a remote device.
		• enable-with-aggressive-backoff - Enables flow
			control with aggressive backoff for specified fast
			ethernet ports.
Sample Output	The following example sets the flow control on all the gigabit ports on the
	module in slot 3 to enable-receive-only.

(configure)# set port flow-control 3 enable-receive-only

Port flow control set: 3/1,3/2

Systems P550R, P580, P880, and P882.

Document No. 10-300090, Issue 1 21-17