Fujitsu SRS-1050 manual Programming Labeling the SET

SRS -1050 Installation ( Appendix B

If you do not assign a DCA, the SRS-1050 will automatically select a default call button.

1.To manually assign the Designated Call Appearance key for your SRS-1050, press 9, ENTER to view the following display:

DESIGNATED CA MODE

SELECT ASSIGN KEY

2.Press the selected Multi- assign key.

DESIGNATED CA REGISTRATION

DSGN CA = ON (1)

3.Press ENTER. The following display is shown. You have the option to turn the selected key ON or OFF.

1:ON2:OFF

SELECT ITEM (1-2)

4.Press 1 or 2 to change the current status, or press ENTER to accept the current status.

DSGN CA=ON	(1)
COMPLETED

Note: If an invalid key is selected for the Designated Call Appearance, the following display is shown.

DESIGNATED CA REGISTRATION (XX) INVALID SELECTION

PROGRAMMING AND

LABELING THE SET

Refer to Chapter 3 for procedures to:

∙Enable headset use and turn off handsfree mode, if desired.

∙Set operating parameters such as ringer volume and tone.

∙Program the calendar/clock and other local features.

To label the buttons on the set, you must first remove the plastic cover over the front panel. Insert a pointed object into the semi - circular notch at the bottom middle of the plastic cover and lift the cover upward.

Below the cover is a template. Write button labels on this template to show the directory numbers or features assigned to each button. Then lay the template back on the front panel. Reinsert the plastic cover.

Page B-20