Fujitsu SRS-1050 manual Switching between Handset and Handsfree Modes

SRS -1050 Voice Features ( Chapter 2

Switching between Handset and Handsfree Modes

If you are using the handset and want to use handsfree mode

Note: These procedures assume that the phone is set to ringing line preference or primary line preference.

1.Press SPEAKER and then replace the handset in its cradle. You now hear the other parties on the call through the speaker.

2.If the MIC-OFF LED is red, the microphone has been turned off. Press MIC-OFF to turn it back on (the LED goes dark). The microphone now picks up your voice.

3.You can turn off the microphone by pressing MIC-OFF, allowing you to hold a private conversation with others in the room. Pressing MIC-OFF again turns the microphone back on.

Note: If the MIC-OFF feature is not active on the upper right corner multifunction button, the microphone is always on.

If you are using handsfree mode and want to use the handset

Pick up the handset. Your call continues without interruption. The handsfree speaker and microphone are turned off.

Placing Handset Calls

If you are not talking on another call

1.Pick up the handset. This should automatically give you a dial tone, if not press an idle Call Appearance (CA).

∙If this connects you with a ringing call, follow the procedure described in the next section.

∙If you want to place the call from a Call Appearance other than the one automatically selected, press its CA button.

2.Dial the desired number by pressing the keys on the numeric keypad.

3.If your call is not answered, you can hang up as follows:

a. Replace the handset in its cradle.

or

Page 2-2