Fujitsu SRS-1050 manual Using the Data Terminal Adapter, Making and Terminating a Data Call

Chapter 4 ( SRS -1050 Data Operation

CHAPTER 4

DATA OPERATION

The SRS-1050 Digital Set is available in a voice/data model that allows you to use the set for data applications. Please refer to the Fujitsu ISDN Data User's Guide for information on how to set up and configure the Terminal Adapter for proper operation.

USING THE DATA TERMINAL ADAPTER

This chapter describes three ways to make a data call using the integrated Terminal Adapter (TA) in your Digital Set.

∙Using the DATA softkey (second button from the left under the display)

∙Using AT commands at your terminal

There are three LEDs below the multifunction buttons of the SRS- 1050. DTR (Data Terminal Ready) must be steady green to establish a connection.

Transmitting data from your terminal causes the TXD (Transmit Data) LED to flash, and receiving data causes the RXD (Receive Data) LED to flash.

MAKING AND TERMINATING A DATA CALL

You can start or end a data call either manually or by using commands at your terminal, as described in the following sections.

Using the DATA Key

To make a data call using the digital set DATA key, follow these steps:

1. Press DATA (softkey 2).

To display the softkey names, press KEY MENU.

Next to the word DATA on the display, a blinking terminal symbol appears, and to its left the word SEND appears for about six seconds.

. . . . . . . . . . . . . . . . . . . . . . . . . . .

SEND DATA CLEAR

2.Use the keypad to enter the number you wish to dial (or press a one-touch button), and press SEND (softkey 1).

Note: The SEND key tells the Digital Set to dial the number. If you don't press SEND, the Digital Set will dial the number after a six second delay.

Page 4-1