Chapter 2 | ( SRS |
The TRANSFER button indicator lights up.
The call is put on hold and its Call Appearance indicator flashes red.
2.An idle CA/DN is selected. Dial the number of the person you want to transfer the call to.
∙If the person answers, you can talk privately before completing the transfer. To place this person on hold without transferring the call, press HOLD. To reconnect with this person, press the DN or CA button.
∙If the line is busy or the person does not answer, press the button in the handset cradle (press SPEAKER if you are using handsfree mode). Then press the flashing Call Appearance button to return to the original call.
Note: To do a "blind" transfer, where you do not talk to the person you are transferring the call to, wait for the person's phone to ring, press the TRANSFER button, and hang up.
3.You can complete the transfer these two ways:
a.After announcing the transfer, just press TRANSFER and hang up.
or
b. To allow all three parties to talk together, press the flashing Call Appearance button again; then press TRANSFER when you want to drop out.
4.Hang up the handset, or, in handsfree mode, press
SPEAKER.
You are disconnected from the call, leaving the other two parties connected.
TRANSFER ï( EWSDï
Transfers a call to another phone and announces the transfer privately
Transfer is a
Note: In Siemens installations, transferring calls is accomplished without a TRANSFER button.
To transfer a call, follow these steps:
1.Answer the incoming call, then while still on the call, press
CONFERENCE.
Page
