Fujitsu SRS-1050 manual Selection 1 Call, Appearance CACH Call, Buttons, Appendix B, Page B-11

Appendix B	( SRS -1050 Installation
Selection 1: Call		∙ Red indicates a button already
Appearance (CACH Call		assigned to a DN, to a
Buttons)		network feature, or to a local
		feature such as one-touch.
Your NISDN SRS-1050's first		∙ Unlit indicates an unassigned
button is set at the factory as
		button.
CA=1. There is no need to
change this when using the	2. Press the button to which you
CACH mode of managing calls.
		want to assign a Call
On a DMS NI1, it may be		Appearance.
necessary to reset button 1 to be
a DN. See instructions under	You can press any unlit or green
Selection 3, in this section.	multifunction button. If you
Your service provider will provide	press a red button, the display
	shows the message INVALID
you with Call Appearance
	SELECTION, and the set waits for
Numbers and associated
	you to press a valid button.
Telephone Numbers. Example:
Telephone Number 555-1212 is		∙ If you press a green button,
your Primary Directory Number
		the display shows the current
and occupies CA 1, 2, and 3.
		number assigned to that
Telephone Number 555-3333 is a
		multifunction button. You can
secondary or shared Telephone
		either enter a new number to
Number and occupies CA 4, 5,
		replace the current number or
and 6. Note that CA numbers are
		cancel the current number.
always distinctive.
1. Press 1 and ENTER (softkey 1).		∙ If you press an unlit button,
		the screen looks like this:
This screen appears:
	CA=	(XX)
CALL APPEARANCE MODE
	. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SELECT ASSIGN KEY
	. . . .
The set's indicators show button
	XX is the number of the
status as follows:
	multifunction button you pressed.
∙ Green indicates a button
	If you pressed a green-lit button,
already assigned to a Call	the current feature number
Appearance.	appears after CA=. The new
	number you enter replaces this
	number.

Page B-11