Fujitsu SRS-1050 Changing Ringer Mode, Switching Back to Handset, only Operation, Chapter, Page

Chapter 3	( SRS -1050 Local Features
4. Press ENTER. This screen		CHANGING RINGER MODE
appears:
		This local feature allows you to:
SUPPORTED
COMPLETED		∙ Change the volume and tone
You can now use the speaker.		of the ringer
		∙ Select the ringer mode, either
The SPEAKER button can control
		normal ring or silent ring.
call pickup or hang-up if the
		Silent ring causes the LED of
handset is in its cradle. The MIC-
		the receiving Call
OFF button (if active) controls the
		Appearance button to flash
microphone if the speaker is in
		green without any ringing
use. If MIC-OFF is pressed, key
		sound.
tones can be heard, but no other
sounds are transmitted until MIC-		∙ Select the ringing pattern you
OFF is pressed again.		will hear when you are
		conversing on another line
Switching Back to Handset-		All settings are made from item 7,
only Operation		RINGER, in menu mode. After
Do steps 1 through 4 (from the		completing a setting, you can
		press asterisk (*) to return to the
previous section), but in steps 3,		menu mode options and change
press 2 instead of 1. The final		another setting, or you can press
screen will look like this instead:		REG (softkey 4) to return to the
		normal display.
NON SUPPORTED
COMPLETED
		Setting Ringer Volume
When the display shows the
selection you prefer, press REG		To set the ringer volume, follow
(softkey 4) to return to the normal
		these steps:
display.
		1. Press REG (softkey 4), 7, ENTER
		(softkey 1). This screen
		appears:
		RINGER SERVICE MODE
		. . . . . . . . . . . . . . . . . . . . . . . . . . .

Page 3-13