Fujitsu SRS-1050 manual Connecting To The, Network, Entering Spids And A D, Channel Tei

SRS -1050 Installation (	Appendix B
CONNECTING TO THE	If you have only one SPID for
NETWORK	both voice and data, enter the
	SPID as a voice SPID only. Do
When you receive your SRS-1050,	not enter the same SPID twice (for
plug the telephone line from the	voice and data).
wall into the LINE socket on the
back of the set. If the display	Do not change your SPID unless
shows a date and time, you have	told to do so by your service
power. If the display does not	provider. In most cases, digital
light up, you may need a power	sets will not work without the
supply to connect to the wall	correct SPID number. If the SPID
socket and to the 40 V DC power	number is wrong, the set displays
socket on the back of the set.	the message SPID NG. Enter the
	correct SPID number, and then
If you are connecting power for	disconnect and reconnect power
the first time, you should see the	to make the set function normally.
message SPID NG. See the next
section to enter a Service Profile	To enter the service profile
Identifier (SPID).	identifiers and the terminal
	endpoint identifier, follow these
	steps:
ENTERING SPIDS AND A D-
CHANNEL TEI	1. Press REGISTER (softkey 4) 8,
	ENTER (softkey 1).
The Service Profile Identifier
identifies your set to the network.	The message ENTER VOICE SPID
If you have a voice/data terminal,	appears, with the current SPID
you may need two SPIDs, one for	number (if any) shown below it.
voice and one for B-channel
	ENTER VOICE SPID
circuit-switched data. You may
also need to enter a D-channel	ID=000000000000
Terminal Endpoint Identifier (TEI)	2. Dial your voice SPID number
for packet-switched data calls.
	and press ENTER.
You can enter the data SPID and
TEI either through this procedure	The display prompts for the data
or through procedures in the
	SPID, if you have a data model.
Data User's Guide.
	ENTER DATA SPID
	ID=

Page B-4