Fujitsu SRS-1050 manual Press ENTER. The Call Announce Intercom selection screen appears

Chapter 3 ( SRS -1050 Local Features

To program the first number and enable Call Announce Intercom, go to step 2.

2.Press ENTER. The Call Announce Intercom selection screen appears:

1:ONE WAY 2:TWO WAY INTERCOM

3:TURN OFF (SELECT 1-3)

3.To enable the intercom feature, dial 1 or 2 and press ENTER. A screen appears showing your choice and prompting for an authorized Directory Number:

TWO WAY SELECTED (1)

ENTER TELEPHONE NUMBER

To disable the intercom feature, dial 3 and press ENTER. When the screen displays the message INTERCOM TURNED OFF, press REGISTER (softkey 4) to return to normal operation.

4.Dial a telephone number of up to ten digits (including wild cards) and press ENTER (softkey 1).

When you press ENTER, a screen appears announcing ONE (or TWO) WAY TURNED ON and showing the number you entered:

TWO WAY TURNED ON 919*926*3112

If a Call Screener has Directory Numbers identified by three, four, or five digit extension numbers, you can dial either the extension number only or the full number. You can also dial an asterisk as a wild card character. See the section introduction for a complete explanation of these choices.

Three Call Screeners can be entered. To program the second or third number, see step 5.

5.Press (*), 11, ENTER, repeat steps 2,3, and 4 as needed until this screen appears:

INTERCOM FEATURE (1)

(ONE OR TWO WAY) 919*926*3112

6.Press NEXT (softkey 2) and this screen appears:

INTERCOM FEATURE (2)

NONSUPPORTED

Note the number (2) on the first line indicating you are about to program your second call screener number. Pressing NEXT repetitively at this prompt will cycle you through all three call screener selections to the one you want to program or change.

Follow steps starting at # 2 to program the last two numbers.

Page 3-21