Fujitsu SRS-1050 manual Receiving Headset Calls, SRS -1050 Voice Features, Chapter, Page

SRS -1050 Voice Features ( Chapter 2

b. Press an idle Call Appearance button to get a dial tone. The call is automatically put on hold.

2.Dial the desired number by pressing the keys on the numeric keypad.

3.If your call is not answered, hang up by pressing the SPEAKER button.

4.If your call is answered, converse with the called party.

5.When the conversation is over, hang up by pressing SPEAKER. Note the displayed call duration; it vanishes after about three seconds.

6.You can pick up the call you were originally talking on, if it was held, by pressing SPEAKER, and if necessary its red-flashing Call Appearance button.

Note: Onhook dialing. In place of steps 1 and 2, you can dial the number first and then press SPEAKER. The phone automatically dials the number. The number you enter remains available for dialing for about three minutes.

You can also use a one-touch button after handling the existing call. This automatically selects an idle CA and dials the number. Skip step 2.

(See also "Handsfree, Handset, and Headset Modes", in Chapter 3, "Local Features".)

Receiving Headset Calls

An incoming call makes the Call Appearance's LED flash green.

If you are not talking on another call

Place the headset on your head in a position comfortable for hearing and talking. If necessary, unplug the handset from the jack on the phone's left side. Plug the headset into the same jack. Also check that headset mode is activated. (See Chapter 3 for details.) The handset, speaker, and microphone will be disabled. All dialing tones and telephone conversation will be audible only through the headset. Your voice and any other transmitted sounds will go through the headset microphone only.

1.Press SPEAKER, and if necessary, press the green- flashing Call Appearance button.

Page 2-10