Fujitsu SRS-1050 Operating the Set with a Headset, Switching from Headset Back to Handset Mode

SRS -1050 Local Features ( Chapter 3

Operating the Set with a Headset

To operate the set with a headset, follow these steps:

1.Press REG (softkey 4), 6, ENTER (softkey 1). This screen appears:

HAND-SET/HEAD-SET MODE

HAND-SET

2.Press ENTER, and this screen appears:

1:HAND-SET 2:HEAD-SET (SELECT 1-2)

3.Press 2. Line 2 changes to (SELECT=2).

4.Press ENTER. This screen appears:

HEAD-SET

COMPLETED

You can now operate the SRS- 1050 using only your headset. The SPEAKER button controls picking up and hanging up calls, and the MIC-OFF button is not operational. The sounds that are usually audible through the speaker, such as the key tones, are now audible only through the headset.

Switching from Headset Back to Handset Mode

Do steps 1 through 4 above, but in step 3, press 1 instead of 2. The final screen will look like this instead:

HAND-SET

COMPLETED

When the display shows the selection you prefer, press REG (softkey 4) to return to the normal display.

Selecting Handsfree Operation (using the speaker and microphone)

To select handsfree operation while in handset mode, follow these steps:

1.Press REG (softkey 4), 5, ENTER (softkey 1). This screen appears:

HANDS-FREE SERVICE MODE

NON SUPPORTED

2.Press ENTER, and this screen appears:

1:SUPPORT 2:NO SUPPORT (SELECT 1-2)

3.Press 1. Line 2 changes to (SELECT=1).

Page 3-12