Fujitsu SRS-1050 manual Selection 4 Intercom/Group Intercom, Selection 5 Conference

Appendix B ( SRS -1050 Installation

XXis the number of the multifunction button you pressed. If you pressed a green-lit button, the current Directory Number appears after DN=. The new number you enter replaces this number.

5.You now have two choices:

∙ To add or change the DN assignment, enter the Directory Number and then press ENTER.

∙ To cancel a DN assignment, press CLEAR (softkey 3) and then press ENTER.

The final screen looks like this:

DN=XXXXXXX(XX)

COMPLETED

If you canceled the current assignment, no numbers appear after DN= and the button indicator goes dark.

Note: If you are assigning multifunction button 1, you must enter the set's primary Directory Number.

6.With your Directory Number assignment complete, you have these choices:

∙To assign another DN button, press the desired button and repeat steps 4 and 5.

∙To return to normal operation, press REGISTER.

∙To make additional button assignments, press any red-lit button and then press asterisk

(*). This returns you to the menu mode main menu.

This completes the programming of Directory Numbers. If you have programmed your SPID correctly, completed this procedure, and your ISDN line is properly plugged in, you should now be ready to place and receive voice calls. If you encounter problems, review these procedures for accuracy.

Selection 4: Intercom/Group Intercom

Press 4 and ENTER. This screen appears:

ICM/GIC MODE

SELECT ASSIGN KEY

From this point, you may assign Intercom and Group Intercom keys using the same process used for Call Appearances.

Selection 5: Conference

It is necessary to assign the conference feature to a key using the following process.

Page B-15