Fujitsu SRS-1050 Announcing a Call by Intercom, Activating and Deactivating the MIC-OFF Button

SRS -1050 Local Features ( Chapter 3

7.Press REGISTER (softkey 4) to return to normal operation.

Announcing a Call by

Intercom

This procedure describes a typical sequence for announcing a call by intercom. The procedure addresses the call screener since the call recipient has little to do. The only action possibly required of the recipient is described in step 3.

The procedure also assumes that both the screener and the call recipient have an SRS-1050 digital set, although only the recipient must have one. If the call screener has some other telephone set, the exact procedure may be different.

This procedure is by no means the only way that you can use Call Announce Intercom.

To announce a call by intercom, follow these steps:

1.Press the Directory Number designated for Call Announce Intercom. The intercom Directory Number indicator lights normally.

2.Dial the extension of the call recipient.

The recipient's SRS-1050 sounds an alert tone, immediately answers the call, and activates the intercom feature.

3. Talk to the recipient.

If the recipient is set up for one- way intercom, pause a few seconds to give the recipient time to press the MIC-OFF button and respond. With two -way intercom, the recipient can respond immediately just by speaking.

Note: To transfer the call at the same time you announce it, use the conference call transfer procedure.

ACTIVATING AND DEACTIVATING THE MIC-OFF BUTTON

The MIC-OFF button (the button at the upper right of the multifunction button array) controls the microphone during handset or handsfree operation. With this button activated as the MIC-0FF button, you can turn off the microphone while on a call to talk privately to people around you, and then press MIC-OFF again to continue your phone conversation.

MIC-OFF is active by default when your SRS-1050 is delivered.

Page 3-22