Fujitsu SRS-1050 manual Mic-Off, Selecting Call Appearance Preference

Chapter 3 ( SRS -1050 Local Features

If you deactivate MIC-OFF, assign the upper right button as a one-touch button, and then try to reactivate MIC-OFF, the button's LED turns red as a warning. You must quit the procedure (press * to return to the menu mode main menus) and cancel the one-touch number before you can reactivate MIC-OFF.

If you try to reactivate MIC-OFF without doing this, the message INVALID SELECTION appears and your attempt fails.

If you are deactivating the MIC- OFF button, make sure the function is turned off (the LED is unlit) before beginning the procedure.

To activate or deactivate MIC- OFF, follow these steps:

1.Press REG (softkey 4), 12, ENTER (softkey 1). A screen appears showing you the current status of MIC-OFF.

MIC -OFF KEY MODE

NON SUPPORTED

2.Press ENTER again and this menu appears:

1:SUPPORT 2:NO SUPPORT (SELECT 1-2)

The LED next to the upper right button indicates its current state:

∙ Off: Unassigned

∙Green: Already active as

MIC-OFF

∙Red: Assigned as a one- touch

If you wish to reactivate MIC- OFF, you must first cancel the one-touch assignment on the upper right button.

3.To activate MIC-OFF, press 1,

ENTER.

To deactivate MIC-OFF, press 2, ENTER.

The screen shows your choice:

SUPPORTED

COMPLETED

4.To return to normal operations, press REG (softkey 4). The standard display screen appears.

SELECTING CALL APPEARANCE PREFERENCE

The preference options determine which Call Appearance button the SRS-1050 selects when you go offhook (lift the receiver or press SPEAKER). You have three choices.

∙Primary line preference. The SRS-1050 always selects button number 1, the Call Appearance associated with your primary Directory Number.

Page 3-23