Fujitsu SRS-1050 manual Call Announce Intercom on, Selected Buttons, Specifying the Directory

Chapter 3	( SRS -1050 Local Features
Call Announce Intercom on		4. All LEDs will light green if "All"
Selected Buttons		was previously selected. Only
		Call Appearances with lit LEDs
Before selecting Directory		will activate on Call Announce.
Numbers for call screeners, you		Press the buttons to turn the
may specify the Call Appearance		LEDs on or off to select the
buttons that are to be answered		desired Call Appearance
automatically. You may select		button(s).
"ALL" buttons or select the
desired Call Appearances.		5. Press ENTER. The following
		screen appears:
To enable or disable Call
		SUPPORTED (SELECT/ALL)
Announce Intercom on selected
buttons, follow these steps:		COMPLETED
1. Press REGISTER (softkey 4), 11,		After selecting the Call
ENTER (softkey 1). A screen		Appearance buttons that are to
appears showing the current		be auto answered, you may
status of the intercom feature:		proceed to select Directory
		Numbers for Call Screeners.
INTERCOM FEATURE
NONSUPPORTED		Specifying the Directory
2. Press ENTER again.		Number for Intercom
The Call Announce Intercom		When enabling the feature, you
		must specify a Directory Number,
button selection screen appears:
		which when used by the screener
		to call the recipient activates the
1: ALL 2: SELECT
		intercom automatically. All
3: NO SUPPORT (SELECT 1-3)		recipients can specify the same
3. To make your choice, dial 1 or 2		Directory Number, for all Call
		Appearance Intercom calls.
and press ENTER. If you		Normal calls can still be made
selected 2, the following screen		from this Directory Number to
appears:		numbers not set up for intercom.
		Up to three Directory Numbers
SUPPORTED (SELECT)		may be programmed.
SELECT ASSIGN KEY

Page 3-19