Fujitsu SRS-1050 manual HANDSFREE, HANDSET, and Headset Modes

Chapter 3 ( SRS -1050 Local Features

To disable unanswered call logging, follow these steps:

1.Press REG (softkey 4), 4, ENTER (softkey 1).

If the following screen appears, the feature is enabled:

UNA SERVICE MODE

SUPPORTED (ALL)

To leave it as is, press REG again.

2.To disable UNA, press ENTER. This screen appears:

1: ALL	2: SELECT
3: NO SUPPORT	SELECT ITEM
(1-3)

3.Now press 3, ENTER, and this screen appears:

NON SUPPORTED

COMPLETED

After about 6 seconds, or if you press asterisk (*), the display returns to the second Service Mode screen:

4: UNA	5: H-FREE
6: HAND/HEAD	SELECT ITEM	(1-
13)

4.You can then select a different menu function, or press REG (softkey 4) to return to the normal display.

HANDSFREE, HANDSET, AND HEADSET MODES

You can set up the Digital Set to use the handset, the speaker, or a headset by selecting from the following modes:

Headset Mode

Enables use as a headset-only phone. You must disconnect the handset from the jack on the phone's left side and plug the headset into the same jack. Calls are connected and disconnected only by your pressing the SPEAKER button. In headset mode, the handsfree mode, including the speaker/microphone, is not supported.

Handset Mode

Enables normal use as a handset phone. While in this mode, the speaker can be enabled or disabled as follows:

Handsfree Supported

Allows speaker use, controlled by SPEAKER button.

Handsfree Non Supported

Disallows speaker use. The SPEAKER button is disabled. Call pickup and hanging up on calls is by handset only.

Page 3-11