SRS | Chapter 2 |
or
b. Retain the call by pressing an idle Call Appearance button to get a dial tone. (The call is automatically put on hold.)
2.To make your call, dial the desired number by pressing the keys on the numeric keypad.
3.If your call is not answered, you can hang up as follows:
a. Replace the handset in its cradle.
or
b. Press the button in the handset cradle to get a dial tone.
4.If your call is answered, converse with the called party.
5.When your conversation ends, you have these choices:
∙Hang up by replacing the handset in its cradle. Note the displayed call duration; it vanishes after about three seconds.
∙If you put your original call on hold, pick up the call by pressing its
Note: You can also use a one- touch button after handling the active call. This automatically dials the number. Skip step 2.
Receiving Handset Calls
An incoming call makes the phone ring and the Call Appearance's LED flash green.
If you are not talking on another call
1.Pick up the handset. (Press the ringing CA if necessary.) The LED changes to steady red.
2.Converse with the calling party.
3.When your conversation ends, hang up by replacing the handset in its cradle. Note the displayed call duration; it vanishes after about three seconds.
If you are already talking on another call
1.Handle the active call in one of the following ways:
a.End the call by pressing the button in the handset cradle. Then press the green- flashing Call Appearance button to answer the incoming call.
Page
