SRS | Chapter 3 |
Selecting Ringer Pattern
This selection determines the type of ring that announces an incoming call when you are conversing on another line.
1.Press REG (softkey 4), 7, ENTER (softkey 1). This screen appears:
RINGER SERVICE MODE
. . . . . . . . . . . . . . . . . . . . . . . . . . .
2.Press ENTER again and this menu appears:
1:VOLUME | 2:TONE |
3:RINGING | (SELECT |
|
|
To see the next menu screen, press NEXT (softkey 2):
4:PATTERN
(SELECT
The selection you want appears on the second screen of the menu, which you can see by pressing NEXT (softkey 2).
3.Press 4, ENTER. A screen appears showing you the current ringer pattern setting:
RINGER PATTERN MODE
MUTE RING
4.Press ENTER again and this menu appears:
1:MUTE RING 2:ONE RING (SELECT
5.Select 1 for a mute ring, a normal ring pattern at reduced volume, or 2 for one ring, which rings once at normal volume. Then press ENTER. The screen shows your selection plus the word COMPLETED:
ONE RING
COMPLETED
6.To return to the normal display, press REG (softkey 4).
Q.931 MESSAGE LOGGING
The Q.931 message logging feature is not supported on this set.
CALL ANNOUNCE INTERCOM
The Call Announce Intercom feature is a convenient way for a person screening incoming calls to announce the call to the intended recipient. The screener places the incoming call on hold, uses a designated Directory Number to announce the call to the recipient via intercom, and may then transfer the call. The screener can also use this feature to deliver a message.
Page
