Fujitsu SRS-1050 Required Support from Your, System Administrator, Numbers of Call Screeners

SRS -1050 Local Features	(	Chapter 3
When specifying the Directory		Required Support from Your
Number for intercom, you must		System Administrator
enter all ten digits of the call
screener number. For example, for		To guarantee that Directory
a call screener at 926-3112, you		Numbers are always available for
could enter:		Call Announce Intercom, the
919 926 3112		System Administrator should:
or		∙ Allocate one Directory Number
919*926*3112
		on the digital sets of both
Entering the full number negates		recipients and screener for
		outgoing calls.
the possibility that an outside call
with the same last four digits in
the calling number (for example,		Specifying the Directory
302 422-3112) could activate the
		Numbers of Call Screeners
intercom.
The asterisks in the number		At the conclusion of selecting
		buttons for Call Announce
919*926*3112 are wild cards. The
		Intercom, this screen appears:
digital set accepts any character
in this position. You need the		SUPPORTED (SELECT/ALL)
wild card to represent the dash	(-	COMPLETED
) if a dash is included in the
number delivered with an		1. Press ENTER. If one or two way
incoming call. If you are in doubt,
		intercom is enabled, the screen
have the person who will be
		displays the enabled mode plus
screening calls call you, and note
		the authorized Directory
the number displayed on the first
		Number, as shown below:
line of the LCD.
The set supports up to three		TWO WAY TURNED ON
		919*926*3112
numbers for screeners. To have
more than three screeners, use *		If no telephone numbers have
as a wild card. For example,
		been programmed in, the Call
entering 919*926*311* allows
		Announce Intercom feature is
both the Directory Numbers 3112
		disabled, and the screen displays
and 3115 to activate the intercom.
		NON SUPPORTED:
Remember, however, that all other
Directory Numbers from 3110 to		INTERCOM FEATURE (1)
3119 would also activate the		NONSUPPORTED
intercom.

Page 3-20