Chapter 3

( SRS -1050 Local Features

The Call Announce Intercom operates in one of two modes, two-way or one-way intercom. Two-way intercom immediately activates the speaker and microphone of the called digital set, allowing two-way communication. One-way intercom activates only the speaker, leaving the microphone of the recipient's digital set turned off in the interest of privacy. The recipient must press the MIC-OFF button to respond to the call screener.

Call Announce Intercom allows you to specify which call buttons are activated by Call Announce Intercom Call Screeners, and allows you to select up to three Call Screeners.

Note: Call Announce Intercom is distinct from Network (Switch provided) intercom.

Ringer Always On

The Call Announce feature utilizes a Ringer Always On mode. Ringer Always On sends a tone to users each time a Call Screener activates Call Announce Intercom (regardless of the ringer mode).

When using network based intercom, only the one or two dialed digits are presented, not the screeners phone number. You could also eliminate dialing entirely with dedicated intercom, another network-based feature.

Figure 3-1 shows a typical application of Call Announce Intercom.

Call Screeners

Call Recipient

í

Directory Numbers Call Announce Intercom setup:

9199263110 Activating Directory

9199263111 Number = 919*926*3112

9199263112* Intercom mode = 1- way or 2-way

*Designated for intercom

Figure 3-1: Call Announce

Intercom Application

This section describes the requirements for setting up Call Announce Intercom followed by the procedures to use Call Announce Intercom to announce a call.

Page 3-17

Page 69
Image 69
Fujitsu SRS-1050 manual Ringer Always On, Call Announce Intercom Application